Use the same procedure for both the RH and LH sides.
The procedure listed below is for the LH side.
87961
1.REMOVE OUTER MIRROR LH
Put protective tape around the outer mirror LH.
Using a moulding remover, detach the 2 claws of the outer mirror LH as shown in the illustration.
| *1 | Moulding Remover |
| *2 | Protective Tape |
Using a moulding remover, detach the 2 claws of the outer mirror LH as shown in the illustration.
| *1 | Moulding Remover |
| *2 | Protective Tape |
Disconnect the connector and remove the outer mirror LH.