CUSTOMIZING FUNCTION WITH INTELLIGENT TESTER (REFERENCE)
The following items can be customized.
When the customer requests a change in a function, first make sure that the function can be customized.
Record the current settings before customizing.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Customize.
Select the setting by referring to the table below.
| Display | Default | Content | Setting |
|---|---|---|---|
| Linked Rear Wiper Washer | AVAIL | Function to make the rear wiper run automatically after the washer function is used. | NOT AVAIL or AVAIL |
| Rewipe Function | AVAIL | Function to make the rear wiper run once automatically for a certain amount of time after the washer function is completed to prevent the dripping of washing fluid. | NOT AVAIL or AVAIL |
| Rear Wiper Interval Speed | 3 sec. | Function used to change the time from when the rear wiper stops moving until it starts moving again in intermittent mode. | 3 sec., 2 sec., 4 sec. or 5 sec. |
| Rear Wiper Retract Time | 3 sec. | Function used to change the time from when the rear wiper stops moving after the rear wiper switch is turned off until the rear wiper is stored in the spoiler. | 3 sec., 4 sec., 5 sec. or 6 sec. |