Home › Vehicle Exterior › WIPER / WASHER › FRONT WIPER MOTOR
RM1440E _59 Vehicle Exterior _056170 WIPER / WASHER _0274190 FRONT WIPER MOTOR A

WIPER / WASHER  FRONT WIPER MOTOR  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 53292A 2.REMOVE UPPER RADIATOR SUPPORT SEAL

Hide 53883F 3.REMOVE FRONT FENDER MAIN SEAL LH

a.
E198982

Detach the 4 clips and 2 guides and remove the front fender main seal LH.


Hide 53882H 4.REMOVE FRONT FENDER MAIN SEAL RH

HINT:

Use the same procedure described for the LH side.


Hide 53867H 5.REMOVE FRONT FENDER TO COWL SIDE SEAL LH

a.
E198989

Detach the 5 claws and remove the front fender to cowl side seal LH.


Hide 53866J 6.REMOVE FRONT FENDER TO COWL SIDE SEAL RH

HINT:

Use the same procedure described for the LH side.


Hide 85292B 7.REMOVE FRONT WIPER ARM HEAD CAP

a.
E198979E01
1.848,0.361 2.053,0.569 0.205,0.208 10 *1 2.022,0.44 2.281,0.44 2.281,0.44 2.502,0.687 false

Using a screwdriver, detach the 3 claws and remove the front wiper arm head cap.

HINT:
·

Tape the screwdriver tip before use.

·

Use the same procedure described for the LH side.



Text in Illustration
*1 Protective Tape


Hide 8.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH

a.
E198980

Remove the nut and the front wiper arm and blade assembly LH.


Hide 9.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH

a.
E198981

Remove the nut and the front wiper arm and blade assembly RH.


Hide 55784B 10.REMOVE CENTER NO. 2 COWL TOP VENTILATOR LOUVER

a.
E198983

Detach the 2 claws and 2 guides and remove the center No. 2 cowl top ventilator louver.


Hide 55781E 11.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

a.
E198984E02
1.854,1.906 2.031,2.073 0.177,0.167 10 false *1 1.333,0.115 1.51,0.281 0.177,0.167 10 false *2

Remove the 2 clips.


b.

Detach the 6 claws and guide (A).

Text in Illustration
*1 Guide A
*2 Guide B


c.

Detach the 9 guides (B) and pull out the cowl top ventilator louver sub-assembly.


Hide 12.REMOVE WINDSHIELD WIPER MOTOR AND LINK

a.
E198985

Detach the clamp and disconnect the connector.


b.
E198986

Remove the 2 bolts.


c.
E198987E02
0.771,0.792 1.563,0.792 1.563,0.792 1.698,0.979 true 0.542,0.708 0.76,0.969 0.219,0.26 10 false *1

Detach the grommet and remove the windshield wiper motor and link as shown in the illustration.

Text in Illustration
*1 Grommet

NOTICE:

Be careful not to damage the windshield when removing the windshield wiper motor and link assembly.



Hide 85110 13.REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

a.
E197622E02
2.531,1.385 1.823,1.385 true 2.573,1.323 2.781,1.552 0.208,0.229 10 false *1

Using a screwdriver, separate the windshield wiper link rod from the crank arm pivot of the front wiper crank sub-assembly as shown in the illustration.

HINT:

Tape the screwdriver tip before use.


Text in Illustration
*1 Protective Tape


b.
E197625

Disconnect the connector.


c.

Using a T30 "TORX" socket, remove the 2 bolts and windshield wiper motor.


Hide 82375B 14.REMOVE WIPER MOTOR WIRE

a.
E197627

Detach the claw and remove the wiper motor wire.