1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
76893
2.REMOVE REAR NO. 1 SPOILER COVER
76085
3.REMOVE REAR SPOILER SUB-ASSEMBLY
4.REMOVE REAR WIPER ARM AND BLADE ASSEMBLY
Remove the nut and rear wiper blade assembly.
85120R
5.REMOVE REAR WIPER MOTOR AND BRACKET ASSEMBLY
Disconnect the connector.
Loosen the 3 bolts.
Do not try to remove the bolts since they are integrated with the motor.
Detach the 2 guides and remove the rear wiper motor