Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH
RM1440E _59 Vehicle Exterior _056170 WIPER / WASHER _0274194 WIPER SWITCH A

WIPER / WASHER  WIPER SWITCH  INSTALLATION  


PROCEDURE

Hide 84650 1.INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY

a.

Attach the claw to install the windshield wiper switch assembly.


b.

Connect the 2 connectors.


Hide 45286B 2.INSTALL UPPER STEERING COLUMN COVER

a.

Attach the claw to install the upper steering column cover.


b.

Attach the 4 clips to install the upper steering column cover to the instrument cluster finish panel.


Hide 45287 3.INSTALL LOWER STEERING COLUMN COVER

a.

Attach the 2 claws to install the lower steering column cover.


b.

Turn the steering wheel to the right and left and install the 2 screws.


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).