Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR(for Front Side) › 2009.08–2013.08
RM1440E _59 Vehicle Exterior _056170 WIPER / WASHER _0274195 WASHER MOTOR(for Front Side) A

WIPER / WASHER  WASHER MOTOR(for Front Side)  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 52119A 2.REMOVE FRONT BUMPER COVER

a.

except X-Runner:

Remove the front bumper cover (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER>REMOVAL).


b.

for X-Runner:

Remove the front bumper cover (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER(for X-Runner)>REMOVAL).


Hide 53875A 3.REMOVE FRONT FENDER LINER RH

a.

Remove the front fender liner (See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA>REMOVAL).


Hide 4.DRAIN WASHER FLUID

a.
E198963

Disconnect the washer hose from the hose of the windshield washer motor and pump assembly and drain the washer fluid.


Hide 85301 5.REMOVE WASHER INLET SUB-ASSEMBLY

a.
E198964

Detach the clip and remove the washer inlet sub-assembly.


Hide 85330 6.REMOVE WASHER JAR

a.
E198971

Disconnect the connector.


b.
E198972

Remove the 3 screws.


c.
E198973

Detach the guide and remove the washer jar.


Hide 85310 7.REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

a.
E197545

Remove the washer motor and pump from the packing of the washer jar.