Home › Vehicle Exterior › WIPER / WASHER › RELAY
RM1440E _59 Vehicle Exterior _056170 WIPER / WASHER _0274198 RELAY G

WIPER / WASHER  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 85941 2.REMOVE WINDSHIELD WASHER RELAY

a.
E201331E02
1.01,3.271 1.01,3.115 1.01,3.115 1.313,2.958 true 0.927,3.302 1.208,3.531 0.281,0.229 10 false *1

Remove the windshield washer relay from the engine room relay box.

Text in Illustration
*1 Windshield Wiper Relay


Hide 85941 3.INSPECT WINDSHIELD WASHER RELAY

a.
B242124E01
1.292,0.74 1.584,0.185 1.584,0.185 1.773,0.185 false 0.708,0.74 1,0.185 1,0.185 1.189,0.185 false 1.789,0.082 1.924,0.258 0.135,0.177 10 2 1.651,1.353 1.763,1.500 0.112,0.147 10 5 1.222,0.082 1.357,0.258 0.135,0.177 10 1 0.98,1.159 1.533,1.457 1.533,1.457 1.621,1.457 false 1.651,1.835 1.763,1.981 0.112,0.147 10 3 0.98,1.64 1.533,1.938 1.533,1.938 1.621,1.938 false

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery voltage applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the windshield washer relay.


Hide 85941 4.INSTALL WINDSHIELD WASHER RELAY

a.

Install the windshield washer relay to the engine room relay box.


Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).