Use the same procedure for both the RH and LH sides.
The procedure listed below is for the LH side.
81562A
1.REMOVE REAR COMBINATION LIGHT GASKET LH
Remove the rear combination light gasket LH.
81550L
2.REMOVE REAR TURN SIGNAL LIGHT BULB
Turn the socket in the direction indicated by the arrow to remove it.
Remove the rear turn signal light bulb.
81550N
3.REMOVE BACK UP LIGHT BULB
Turn the socket in the direction indicated by the arrow and remove it.
Remove the back up light bulb.
81565
4.REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE LH
Remove the screw.
Detach the 3 clamps.
Disconnect the connector and remove the rear combination light socket and wire LH.