Use the same procedure for both the RH and LH sides.
The procedure listed below is for the LH side.
81565
1.INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE LH
Connect the connector.
Attach the 3 clamps to install the rear combination light socket and wire LH.
Install the screw.
81550N
2.INSTALL BACK UP LIGHT BULB
Install the back up light bulb.
Turn the socket in the direction indicated by the arrow to install it.
81550L
3.INSTALL REAR TURN SIGNAL LIGHT BULB
Install the rear turn signal light bulb.
Turn the socket in the direction indicated by the arrow to install it.
81562A
4.INSTALL REAR COMBINATION LIGHT GASKET LH
Install a new rear combination light gasket LH.