84340
1.INSPECT STOP LIGHT SWITCH ASSEMBLY
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Pin pushed | 10 kΩ higher |
| Pin not pushed | Below 8.3 Ω | |
| 3 - 4 | Pin pushed | Below 1.6 Ω |
| Pin not pushed | 10 kΩ higher |
If the result is not as specified, replace the stop light switch assembly.
| *a | Not Pushed |
| *b | Pushed |