Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH › from 2013.08
RM1440E _59 Vehicle Exterior _056171 LIGHTING (EXT) _0274209 STOP LIGHT SWITCH G

LIGHTING (EXT)  STOP LIGHT SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 84340 1.INSPECT STOP LIGHT SWITCH ASSEMBLY

a.
U150552E01
1.531,0.291 1.803,0.446 0.272,0.156 10 A47 0.18,0.156 0.333,0.312 0.152,0.156 10 *a 0.988,1.72 1.317,1.876 0.329,0.156 10 GND 1.351,1.19 1.179,1.699 false 2.174,1.72 2.286,1.876 0.112,0.156 10 B 2.022,1.19 2.194,1.699 false 2.518,1.72 2.633,1.876 0.115,0.156 10 B 2.211,1.19 2.52,1.699 false

Disconnect the connector from the stop light switch assembly.


b.

Measure the voltage according to the value (s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A47-7 (B) - A47-2 (GND) Ignition switch off 11 to 14 V
A47-6 (B) - A47-2 (GND) Ignition switch ON 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Stop Light Switch Assembly)


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A47-2 (GND) - Body ground Always Below 1 Ω



d.
U150551E01
1.539,0.411 1.812,0.567 0.272,0.156 10 A47 0.18,0.156 0.337,0.312 0.157,0.156 10 *a 0.73,1.72 0.829,1.876 0.099,0.156 10 L 1.558,1.127 0.839,1.703 false 1.057,1.72 1.393,1.876 0.336,0.156 10 ACC 1.689,1.127 1.286,1.703 false 2.344,1.72 2.672,1.876 0.328,0.156 10 GND 1.916,1.127 2.508,1.703 false 2.928,1.72 3.256,1.876 0.328,0.156 10 OUT 2.071,1.127 3.041,1.703 false 2.034,1.72 2.133,1.876 0.099,0.156 10 L 1.813,1.127 2.061,1.703 false

Reconnect the connector to the stop light switch assembly.


e.

Measure the voltage according to the value (s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A47-1 (OUT) - A47-2 (GND) Ignition switch off, brake pedal not depressed Below 1 V
A47-1 (OUT) - A47-2 (GND) Ignition switch off, brake pedal depressed 11 to 14 V
A47-3 (L) - A47-2 (GND) Ignition switch off, brake pedal not depressed Below 1 V
A47-4 (ACC) - A47-2 (GND) Ignition switch off 11 to 14 V
A47-3 (L) - A47-2 (GND) Ignition switch off, brake pedal depressed 11 to 14 V
A47-5 (L) - A47-2 (GND) Ignition switch ON, brake pedal not depressed 11 to 14 V
A47-5 (L) - A47-2 (GND) Ignition switch ON, brake pedal depressed Below 1 V


Text in Illustration
*a Component with harness connected
(Stop Light Switch Assembly)

If the result is not as specified, replace the stop light switch assembly.