Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM
RM1440E _59 Vehicle Exterior _056171 LIGHTING (EXT) _0274213 LIGHTING SYSTEM U

LIGHTING (EXT)  LIGHTING SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body Electrical / Main Body / Data List.


e.

According to the display on the intelligent tester, read the Data List.

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
ACC SW Ignition switch ACC signal / ON or OFF ON: Ignition switch ACC
OFF: Ignition switch off
-
IG SW Ignition switch ON signal / ON or OFF ON: Ignition switch ON
OFF: Ignition switch off
-
FL Door Courtesy SW Front door courtesy light switch LH signal / ON or OFF ON: Front door LH closed
OFF: Front door LH open
-
Dimmer SW Headlight dimmer switch high signal / ON or OFF ON: Headlight dimmer switch in high or high flash
OFF: Headlight dimmer switch in low
-
Passing Light SW Headlight dimmer switch high flash signal / ON or OFF ON: Headlight dimmer switch in high flash
OFF: Headlight dimmer switch not in high flash
-
Front Fog Light SW Front fog light switch signal / ON or OFF ON: Front fog light switch on
OFF: Front fog light switch off
-
Auto Light SW* Headlight dimmer switch AUTO signal / ON or OFF ON: Headlight dimmer switch in AUTO
OFF: Headlight dimmer switch not in AUTO
-
Head Light SW (Head) Headlight dimmer switch head signal / ON or OFF ON: Headlight dimmer switch in head
OFF: Headlight dimmer switch not in head
-
Head Light SW (Tail) Headlight dimmer switch tail signal / ON or OFF ON: Headlight dimmer switch in tail or head
OFF: Headlight dimmer switch not in tail or head
-
Illumination Rate Info* Illumination rate information / 0 ms. to 99.99 ms. Value is output according to ambient light levels -

*: w/ Automatic Light Control System




ACTIVE TEST


HINT:

Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body Electrical / Main Body / Active Test.


e.

According to the display on the intelligent tester, perform the Active Test.

Main Body
Tester Display Test Part Control Range Diagnostic Note
Hazard Hazard signal ON/OFF -
Taillight Relay Taillight relay ON/OFF -
Headlight Relay Low beam headlight relay ON/OFF -
Head Light Hi Headlight dimmer relay ON/OFF -
Front Fog Light Relay Front fog light relay ON/OFF -