Home › Vehicle Exterior › HORN › INTEGRATION RELAY
RM1440E _59 Vehicle Exterior _056172 HORN _0274215 INTEGRATION RELAY G

HORN  INTEGRATION RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 82662A 1.REMOVE NO. 1 RELAY BLOCK COVER

Hide 82641 2.INSPECT NO. 1 INTEGRATION RELAY

a.
B236388E01
1.351,0.06 1.526,0.221 0.174,0.161 10 *1 2.043,0.06 2.217,0.221 0.174,0.161 10 *1 1.324,0.169 1.066,0.169 1.066,0.169 0.658,0.311 false 2.226,0.143 2.437,0.143 2.437,0.143 2.862,0.285 false

Using a screwdriver, detach the 2 claws and disconnect the integration relay from the engine room junction block.

HINT:

Tape the screwdriver tip before use.


Text in Illustration
*1 Protective Tape


b.
U180708E02
0.094,0 0.26,0.177 0.167,0.177 10 false *a 2.396,0.385 2.677,0.583 0.281,0.198 10 false 1A 0.479,0.396 0.771,0.583 0.292,0.188 10 false 1C

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1A-8 - 1C-1 Battery voltage is not applied to terminals 1A- 6 and 1A-7 10 kΩ or higher
1A-8 - 1C-1 Battery voltage is applied to terminals 1A- 6 and 1A-7 Below 1Ω


If the result is not as specified, replace the integration relay

Text in Illustration
*a Component with harness connected
(Integration Relay)


c.

Attach the 2 claws to install the integration relay to the engine room junction block.


Hide 82662A 3.INSTALL NO. 1 RELAY BLOCK COVER