58766A
1.REMOVE JACK BOX HOLE COVER
Put protective around the jack box hole cover.
Using a moulding remover, Detach the 2 claws and 2 guides and remove the jack box hole cover.
| *1 | Protective Tape |
| *2 | Moulding Remover |
76626E
2.REMOVE REAR QUARTER PANEL MUDGUARD LH
76625G
3.REMOVE REAR QUARTER PANEL MUDGUARD RH
Use the same procedure as for the LH side.
52159
4.REMOVE REAR BUMPER COVER
Remove the 2 bolts and 2 screws.
Put protective tape around the rear bumper cover.
Remove the 2 screws and 6 bolts.
Detach the 18 claws to remove the rear bumper cover.
| *1 | Protective Tape | - | - |
52615
5.REMOVE REAR BUMPER ENERGY ABSORBER
Remove the rear bumper energy absorber.
52174D
6.REMOVE REAR BUMPER BAR REINFORCEMENT LH
Remove the 3 bolts and rear bumper bar reinforcement LH.
52173D
7.REMOVE REAR BUMPER BAR REINFORCEMENT RH
Use the same procedure as for the LH side.
52156A
8.REMOVE REAR BUMPER SIDE SUPPORT LH
Remove the 3 screws.
Detach the 5 claws to remove the rear bumper side support LH.
52155A
9.REMOVE REAR BUMPER SIDE SUPPORT RH
Use the same procedure as for the LH side.
81561D
10.REMOVE REAR COMBINATION LIGHT LENS AND BODY LH
81551D
11.REMOVE REAR COMBINATION LIGHT LENS AND BODY RH
Use the same procedure as for the LH side.
52563D
12.REMOVE REAR BUMPER UPPER RETAINER LH
Detach the 2 clips to remove the rear bumper upper retainer LH.
52562E
13.REMOVE REAR BUMPER UPPER RETAINER RH
Use the same procedure as for the LH side.
51909B
14.REMOVE PINTLE HOOK SUPPORT TUBE SUB-ASSEMBLY (w/ Pintle Hook)
Remove the 6 bolts and pintle hook support tube sub-assembly.