A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
51909B
1.INSTALL PINTLE HOOK SUPPORT TUBE SUB-ASSEMBLY (w/ Pintle Hook)
52563D
2.INSTALL REAR BUMPER UPPER RETAINER LH
52562E
3.INSTALL REAR BUMPER UPPER RETAINER RH
Use the same procedure described for the LH side.
81561D
4.INSTALL REAR COMBINATION LIGHT LENS AND BODY LH
81551D
5.INSTALL REAR COMBINATION LIGHT LENS AND BODY RH
Use the same procedure described for the LH side.
52156A
6.INSTALL REAR BUMPER SIDE SUPPORT LH
52155A
7.INSTALL REAR BUMPER SIDE SUPPORT RH
Use the same procedure described for the LH side.
52174D
8.INSTALL REAR BUMPER BAR REINFORCEMENT LH
Install the rear bumper bar reinforcement with the 2 bolts.
52173D
9.INSTALL REAR BUMPER BAR REINFORCEMENT RH
Use the same procedure described for the LH side.
52615
10.INSTALL REAR BUMPER ENERGY ABSORBER
52159
11.INSTALL REAR BUMPER COVER
Attach the 18 claws to install the rear bumper cover.
Install the 8 bolts and 4 screws.
76626E
12.INSTALL REAR QUARTER PANEL MUDGUARD LH
76625G
13.INSTALL REAR QUARTER PANEL MUDGUARD RH
Use the same procedure described for the LH side.