A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
76889D
1.INSTALL REAR NO. 2 SPOILER CLIP
Use the same procedure to install the rear No. 2 spoiler clip on the other side.
Attach the 2 claws to install a new rear No. 2 spoiler clip.
76085
2.INSTALL REAR SPOILER SUB-ASSEMBLY
Attach the 3 claws to install the rear spoiler.
Connect the connector.
Install the 4 bolts and 4 grommets.
76893
3.INSTALL REAR NO. 1 SPOILER COVER
Attach the 4 clips to install the rear No. 1 spoiler cover.