Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR SPOILER
RM1440E _59 Vehicle Exterior _056173 EXTERIOR PANELS / TRIM _0274221 REAR SPOILER A

EXTERIOR PANELS / TRIM  REAR SPOILER  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:

When installing the rear spoiler protector, heat the rear spoiler surface using a heat light.


Standard:
Item Temperature
Rear Spoiler 20 to 30°C (68 to 86°F)


PROCEDURE

Hide 82188A 1.INSTALL NO. 3 BACK DOOR WIRE

a.

Attach the clamp to install the No. 3 back door wire.


Hide 76874B 3.INSTALL REAR SPOILER PROTECTOR LH

HINT:

Use the same procedure to install the rear spoiler protector on the other side.


B240313

a.

Clean the rear spoiler surface.

i.

Using a heat light, heat the rear spoiler surface.


ii.

Remove the double-sided tape from the rear spoiler surface.


iii.

Wipe off any tape adhesive residue with cleaner.



b.

Install a new rear spoiler protector.

i.

Remove the peeling paper from the face of a new rear spoiler protector.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



ii.

Install the rear spoiler protector as shown in the illustration.



Hide 76873B 4.INSTALL REAR NO. 2 SPOILER PROTECTOR

HINT:

Use the same procedure to install the rear No. 2 spoiler protector on the other side.


B240312

a.

Clean the rear spoiler surface.

i.

Using a heat light, heat the rear spoiler surface.


ii.

Remove the double-sided tape from the rear spoiler surface.


iii.

Wipe off any tape adhesive residue with cleaner.



b.

Install a new rear No. 2 spoiler protector.

i.

Remove the peeling paper from the face of a new rear No. 2 spoiler protector.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



ii.

Install the rear No. 2 spoiler protector as shown in the illustration.



Hide 76872A 5.INSTALL REAR NO. 1 SPOILER PROTECTOR

HINT:

Use the same procedure to install the rear No. 1 spoiler protector on the other side.


B240311

a.

Clean the rear spoiler surface.

i.

Using a heat light, heat the rear spoiler surface.


ii.

Remove the double-sided tape from the rear spoiler surface.


iii.

Wipe off any tape adhesive residue with cleaner.



b.

Install a new rear No. 1 spoiler protector.

i.

Remove the peeling paper from the face of a new rear No. 1 spoiler protector.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



ii.

Install the rear No. 1 spoiler protector as shown in the illustration.