Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
63472
1.INSTALL FRONT ROOF RACK LEG LH
Clean the threads of the "TORX" screw with non-residue solvent (when reusing the "TORX" screw).
Apply adhesive to the threads of the "TORX" screw (when reusing the "TORX" screw).
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.
Using a T30 "TORX" socket wrench, install the front roof rack leg with the 2 "TORX" screws.
63474
2.INSTALL REAR ROOF RACK LEG LH
Clean the threads of the "TORX" screw with non-residue solvent (when reusing the "TORX" screw).
Apply adhesive to the threads of the "TORX" screw (when reusing the "TORX" screw).
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.
Using a T30 "TORX" socket wrench, install the rear roof rack leg with the 2 "TORX" screws.
63442A
3.INSTALL NO. 1 ROOF CARRIER SUPPORT LH
Attach the 2 claws to install the No. 1 roof carrier support.
63444A
4.INSTALL ROOF RACK PROTECTOR LH
Attach the 2 claws to install the roof rack protector.
63487A
5.INSTALL FRONT ROOF RACK LEG CUSHION LH
Attach the 4 claws to install the front roof rack leg cushion.
63489
6.INSTALL REAR ROOF RACK LEG CUSHION LH
Attach the 4 claws to install the rear roof rack leg cushion.