Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
76622D
1.REMOVE FRONT FENDER MUDGUARD LH
75852
2.REMOVE ROCKER PANEL MOULDING LH
Put protective tape around the rocker panel moulding.
Remove the 4 screws.
Detach the 15 clips and remove the rocker panel moulding.
| *1 | Protective Tape | - | - |
61429
3.REMOVE NO. 6 ROCKER PANEL REINFORCEMENT
Remove the 6 bolts and No. 6 rocker panel reinforcement.
75862A
4.REMOVE NO. 2 ROCKER PANEL MOULDING PROTECTOR
Remove the 2 screws and No. 2 rocker panel moulding protector.