Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › SIDE MOULDING › 2009.08–2011.10
RM1440E _59 Vehicle Exterior _056173 EXTERIOR PANELS / TRIM _0274229 SIDE MOULDING A

EXTERIOR PANELS / TRIM  SIDE MOULDING  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

When installing the pad, heat the moulding surface using a heat light.



Standard:
Item Temperature
Moulding 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the moulding excessively.


PROCEDURE

Hide 75692A 1.INSTALL FRONT FENDER OUTSIDE MOULDING PAD LH

a.

Clean the front fender outside moulding surface.

i.

Using a heat light, heat the front fender outside moulding surface.


ii.

Remove the double-sided tape from the front fender outside moulding surface.


iii.

Wipe off any tape adhesive residue with cleaner.



b.
B239373

Install a new front fender outside moulding pad.

i.

Remove the peeling paper from the face of a new front fender outside moulding pad.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



ii.

Install the front fender outside moulding pad.



Hide 75767A 2.INSTALL REAR DOOR NO. 1 MOULDING PAD

a.

Clean the rear door outside moulding surface.

i.

Using a heat light, heat the rear door outside moulding surface.


ii.

Remove the double-sided tape from the rear door outside moulding surface.


iii.

Wipe off any tape adhesive residue with cleaner.



b.
B239375

Install a new rear door No. 1 outside moulding pad.

i.

Remove the peeling paper from the face of a new rear door No. 1 outside moulding pad.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



ii.

Install the rear door No. 1 outside moulding pad.



Hide 75797C 3.INSTALL REAR DOOR UPPER OUTSIDE MOULDING PAD

a.

Clean the rear door outside moulding surface.

i.

Using a heat light, heat the rear door outside moulding surface.


ii.

Remove the double-sided tape from the rear door outside moulding surface.


iii.

Wipe off any tape adhesive residue with cleaner.



b.
B239374

Install a new rear door upper outside moulding pad.

i.

Remove the peeling paper from the face of a new rear door upper outside moulding pad.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



ii.

Install the rear door upper outside moulding pad.



Hide 75659A 4.INSTALL NO. 1 QUARTER PANEL MOULDING PAD

a.

Clean the rear quarter outside moulding surface.

i.

Using a heat light, heat the rear quarter outside moulding surface.


ii.

Remove the double-sided tape from the rear quarter outside moulding surface.


iii.

Wipe off any tape adhesive residue with cleaner.



b.
B239376

Install a new No. 1 quarter panel moulding pad.

i.

Remove the peeling paper from the face of a new No. 1 quarter panel moulding pad.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



ii.

Install the No. 1 quarter panel moulding pad as shown in the illustration.