Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
When installing the pad, heat the moulding surface using a heat light.
| Item | Temperature |
|---|---|
| Moulding | 20 to 30°C (68 to 86°F) |
Do not heat the moulding excessively.
75692A
1.INSTALL FRONT FENDER OUTSIDE MOULDING PAD LH
Only follow this procedure when replacing the front fender outside moulding pad LH.
Install a new front fender outside moulding pad LH in the position shown in the illustration.
75767A
2.INSTALL REAR DOOR NO. 1 MOULDING PAD
Clean the rear door outside moulding surface.
Using a heat light, heat the rear door outside moulding surface.
Remove the double-sided tape from the rear door outside moulding surface.
Wipe off any tape adhesive residue with cleaner.
Install a new rear door No. 1 outside moulding pad.
Remove the peeling paper from the face of a new rear door No. 1 outside moulding pad.
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
Install the rear door No. 1 outside moulding pad.
75797C
3.INSTALL REAR DOOR UPPER OUTSIDE MOULDING PAD
Clean the rear door outside moulding surface.
Using a heat light, heat the rear door outside moulding surface.
Remove the double-sided tape from the rear door outside moulding surface.
Wipe off any tape adhesive residue with cleaner.
Install a new rear door upper outside moulding pad.
Remove the peeling paper from the face of a new rear door upper outside moulding pad.
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
Install the rear door upper outside moulding pad.
75659A
4.INSTALL NO. 1 QUARTER PANEL MOULDING PAD
Clean the rear quarter outside moulding surface.
Using a heat light, heat the rear quarter outside moulding surface.
Remove the double-sided tape from the rear quarter outside moulding surface.
Wipe off any tape adhesive residue with cleaner.
Install a new No. 1 quarter panel moulding pad.
Remove the peeling paper from the face of a new No. 1 quarter panel moulding pad.
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
Install the No. 1 quarter panel moulding pad as shown in the illustration.