When installing the symbol emblem, No. 1 back door emblem, No. 2 back door name plate and No. 1 roof side mark, heat the vehicle body, symbol emblem, No. 1 back door emblem, No. 2 back door name plate and No. 1 roof side mark using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Symbol Emblem | 20 to 30°C (68 to 86°F) |
| No. 1 Back Door Emblem | 20 to 30°C (68 to 86°F) |
| No. 2 Back Door Name Plate | 20 to 30°C (68 to 86°F) |
| No. 1 Roof Side Mark | 20 to 30°C (68 to 86°F) |
Do not heat the vehicle body, symbol emblem, No. 1 back door emblem or No. 1 roof side mark excessively.
75741E
1.INSTALL SYMBOL EMBLEM
Clean the vehicle body surface.
Using a heat light, heat the vehicle body surface.
Remove the double-sided tape from the vehicle body.
Wipe off any tape adhesive residue with cleaner.
Install a new symbol emblem.
Using a heat light, heat the vehicle body and a new symbol emblem.
Remove the peeling paper from the face of the symbol emblem.
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
Align the boss positions and install the symbol emblem.
Press the symbol emblem firmly to install it.
| *1 | Boss |
75431A
2.INSTALL NO. 1 BACK DOOR EMBLEM
Clean the vehicle body surface.
Using a heat light, heat the vehicle body surface.
Remove the double-sided tape from the vehicle body.
Wipe off any tape adhesive residue with cleaner.
Install a new No. 1 back door emblem.
Using a heat light, heat the vehicle body and a new No. 1 back door emblem.
Remove the peeling paper from the face of the No. 1 back door emblem.
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
Install the No. 1 back door emblem in the position shown in the installation.
| *a | Reference Value | - | - |
75442A
3.INSTALL NO. 2 BACK DOOR NAME PLATE
Clean the vehicle body surface.
Using a heat light, heat the vehicle body surface.
Remove the double-sided tape from the vehicle body.
Wipe off any tape adhesive residue with cleaner.
Install a new No. 2 back door name plate.
Using a heat light, heat the vehicle body and a new No. 2 back door name plate.
Remove the peeling paper from the face of the No. 2 back door name plate.
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
Install the No. 2 back door name plate in the position shown in the installation.
| *a | Reference Value | - | - |
75455A
4.INSTALL NO. 1 ROOF SIDE MARK
Clean the vehicle body surface.
Using a heat light, heat the vehicle body surface.
Remove the double-sided tape from the vehicle body.
Wipe off any tape adhesive residue with cleaner.
Install a new No. 1 roof side mark.
Using a heat light, heat the vehicle body and a new No. 1 roof side mark.
Remove the peeling paper from the face of the No. 1 roof side mark.
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
Install the No. 1 roof side mark in the position shown in the installation.
| *a | Reference Value | *b | Over Fender End Line |