Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
75862A
1.INSTALL NO. 2 ROCKER PANEL MOULDING PROTECTOR
Install the No. 2 rocker panel moulding protector with the 2 screws.
75852
2.INSTALL ROCKER PANEL MOULDING LH
Attach the 7 clips to install the rocker panel moulding.
Install the 2 screws.
Install the 7 retainers, screw and clip.
3.INSTALL SIDE STEP ASSEMBLY LH (w/ Side Step)
Install the side step (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>SIDE STEP>INSTALLATION).