Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE SIDE STEP ASSEMBLY LH (w/ Side Step)
Remove the side step (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>SIDE STEP>REMOVAL).
75852
2.REMOVE ROCKER PANEL MOULDING LH
Remove the 7 retainers, clip and screw.
Put protective tape around the rocker panel moulding.
Remove the 2 screws.
Detach the 7 clips and remove the rocker panel moulding.
| *1 | Protective Tape | - | - |
75862A
3.REMOVE NO. 2 ROCKER PANEL MOULDING PROTECTOR
Remove the 2 screws and No. 2 rocker panel moulding protector.