ELECTRIC POWER CONTROL SYSTEM > DETAILS



SYSTEM CONTROL
  1. The electric power control system has the following control:

    Control
    Outline
    Starting Control (Cranking Hold)
    Starting control outputs an operation request to the starter motor in accordance with the cranking status.
    Power Source Control (For details, Click here)
    Power source control switches the IG1 relay, IG2 relay or ACC relays on or off in accordance with the engine switch status (power source mode).
    Gateway Function
    Gateway control serves as a gateway to transmit data between buses.


OPERATION


  1. Starter Control (Cranking Hold)

    1. When the engine switch is pressed, the power management control ECU receives a start signal. When the power management control ECU receives this signal, in order to operate the starter, the power management control ECU sends power from its STAR terminal to the starter relay.



    2. The power is sent via the park/neutral position switch when the shift lever is in either P or N. At this time, the power management control ECU turns off the ACC relay by turning off the power sent from the ACCD terminal. The ACC relay is turned off to prevent flickering of the meters, clock and audio system.


      Y104097E02

    3. While cranking, the power management control ECU continues energizing the starter relay until it is determined that the engine has started. The power management control ECU and ECM are both used to judge if the engine has started. When it has been judged that the engine has started, the power management control ECU stops energizing the starter relay.



    4. If the engine does not start, the starter operates for a length of time that is based on coolant temperature.


      Y104091E01

    5. This system has following safety features:

      1. While the engine is running, the starter cannot operate.
      2. The starter will stop operating once the engine has started, even if the engine switch remains pushed.
      3. Starter operation is limited to a maximum of 30 seconds to protect the starter motor.
      4. The starter will stop if the ECM cannot detect an engine speed signal (NE) while the starter is operating.