Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › YAW RATE AND ACCELERATION SENSOR

YAW RATE AND ACCELERATION SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY
  1. Remove the rear console box sub-assembly (Click here).



3. REMOVE YAW RATE AND ACCELERATION SENSOR


    C212848
  1. Remove the 2 bolts and yaw rate and acceleration sensor.

  1. Disconnect the connector, and then detach the clamp from the sensor bracket.