Home › General › INTRODUCTION › REPAIR INSTRUCTION

REPAIR INSTRUCTION > INITIALIZATION



PROCEDURES NECESSARY WHEN CABLE IS DISCONNECTED/RECONNECTED TO BATTERY TERMINAL

Procedures Necessary when Cable is Disconnected/Reconnected to Battery Terminal 
Necessary Procedure
Effect or Inoperative Function when Necessary Procedure is not Performed
See page
Reset back door unlock position
Back door unlock function
Click here

NOTICE:
  1. After the battery is reconnected, be sure to wait 10 seconds or more before attempting to start the engine. The engine may not start immediately after the battery is reconnected.


PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED

Procedures Necessary when ECU or Other Parts are Replaced 
Replacement Part
Necessary Procedure
Effect or Inoperative Function when Necessary Procedure is not Performed
See Page
  1. Throttle body with motor assembly
  2. Cleaning the deposits from the throttle body with motor assembly
  3. Engine assembly
  4. Cylinder head
  5. Camshaft (for intake or exhaust camshaft)
  6. Camshaft timing gear assembly
  7. Piston or piston ring
  8. Mass air flow meter
  9. Fuel injector assembly
  10. Fuel pump
  11. Air fuel ratio sensor
  12. Heated oxygen sensor
  13. Engine coolant temperature sensor
  14. Spark plug
  15. Ignition coil assembly
  16. Air leaks from intake system
  17. Gas leaks from exhaust system
  18. Knock control sensor
Initialization
Engine control system
Click here
ECM
Register VIN.
DTC P0630 is output
Click here
  1. Automatic transmission assembly (for A750F)
  2. Valve body assembly (for A750F)
  3. Any of the shift solenoid valve (for A750F)
Reset memory
Large shift shock
Click here
  1. Automatic transmission assembly (for A750E)
  2. Valve body assembly (for A750E)
  3. Any of the shift solenoid valve (for A750E)
Reset memory
Large shift shock
Click here
  1. Tire pressure warning ECU
  2. Tire pressure warning valve and transmitter
Code registration
Tire pressure warning system
Click here
  1. Master cylinder solenoid
  2. Yaw rate and acceleration sensor
  3. Spiral cable sub-assembly (steering angle sensor)
Calibration
Vehicle stability control system
Click here
Garage door opener transmitter
Registration
Garage door opener system
Click here
DCM (Telematics Transceiver)
DCM Activation
Safety connect system does not operative
Click here
  1. Steering lock actuator assembly
  2. Certification ECU
  3. ID code box
  4. Key
Code registration
  1. Engine immobiliser system (w/ Smart Key System)
  2. Engine start
  3. Steering lock and unlock
Click here
  1. Transponder key ECU
  2. ECM
  3. Key
Code registration
  1. Engine immobiliser system (w/o Smart Key System)
  2. Engine start
Click here
  1. Door control receiver assembly
  2. Key
Code registration
Wireless door lock control system (w/o Smart Key System)
Click here
  1. Front power window regulator motor LH
  2. Front power window regulator motor RH
  3. Rear power window regulator motor LH
  4. Rear power window regulator motor RH
  5. Back door power window regulator motor
Motor initialization
Power window control system
Click here
  1. Sliding roof ECU (sliding roof drive gear sub-assembly)
  2. Sliding roof glass
  3. Sliding roof housing
Sliding roof system initialization
Auto operation
Click here
Side auto step controller ECU assembly
Automatic running board system initialization
Automatic running board system
Click here