Home › Engine / Hybrid System › 1GR-FE COOLING › WATER PUMP

WATER PUMP > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE FAN SHROUD
  1. Remove the fan shroud (Click here).



2. INSPECT WATER PUMP ASSEMBLY


    A174302E02
  1. Visually check the air hole and water hole for coolant leakage.
    Text in Illustration 
    *1
    Water Hole
    *2
    Air Hole
    If leakage is found, replace the water pump assembly.

  1. Turn the pulley and check that the water pump bearing moves smoothly and quietly.
    If necessary, replace the water pump assembly.



3. INSPECT FLUID COUPLING ASSEMBLY


    A224910
  1. Remove the 4 nuts and fan.



    A224914
  1. Check the fluid coupling for damage or silicon oil leaks.
    If necessary, replace the fluid coupling.

  1. Install the fan with the 4 nuts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



4. INSTALL FAN SHROUD
  1. Install the fan shroud .