GARAGE DOOR OPENER SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT GARAGE DOOR OPENER |
![]() |
Press each switch and check that the red LED turns on. If one or more of the switches does not turn on the LED, confirm normal operation of the fuse and wire harness. If the fuse and wire harness are malfunctioning, replace them. If not, replace the garage door opener (map light assembly) (Click here).
| *1 | These Switches |
| *2 | LED |
| 2. INSPECT GARAGE DOOR OPENER REGISTRATION AND TRANSMITTING |
![]() |
Check if the test transmitter code was successfully registered.
| *1 | Test Transmitter |
| *2 | Press |
![]() |
Press the garage door opener switch that was registered to the tester transmitter. Check if the green LED of the "HomeLink" tester illuminates.
When the inspection is complete, register the customer transmitter code(s) again.
| *1 | Press |
| *2 | "HomeLink" Tester |