Home › Drivetrain ยท A750F AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM

AUTOMATIC TRANSMISSION SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. The ECM is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Refer to How to Troubleshoot ECU Controlled Systems in the Introduction section (Click here).


    NEXT


    3.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    4.CONNECT TECHSTREAM TO DLC3*

      NEXT


      5.CHECK AND CLEAR DTCS AND FREEZE FRAME DATA*
      1. Refer to DTC Check / Clear (Click here).


      NEXT


      6.VISUAL INSPECTION

        NEXT


        7.SETTING CHECK MODE DIAGNOSIS*
        1. Refer to Check Mode Procedure (Click here).


        NEXT


        8.PROBLEM SYMPTOM CONFIRMATION
        1. Refer to Road Test (Click here).
          Result 
          Result
          Proceed to
          Symptom does not occur
          A
          Symptom occurs
          B



        B.
        GO TO STEP 10
        A


        9.SYMPTOM SIMULATION
        1. Refer to Electronic Circuit Inspection Procedure (Click here).


        NEXT


        10.DTC CHECK*
        1. Refer to DTC Check / Clear (Click here).
          Result 
          Result
          Proceed to
          DTC is not output
          A
          DTC is output
          B



        B.
        GO TO STEP 19
        A


        11.BASIC INSPECTION
        1. Refer to Automatic Transmission Fluid (Click here).

        2. Refer to Park/Neutral Position Switch (Click here).

        3. Refer to Shift Lever Assembly (Click here).



        NG.
        GO TO STEP 22
        OK


        12.MECHANICAL SYSTEM TESTS
        1. Refer to Mechanical System Tests (Click here).



        NG.
        GO TO STEP 18
        OK


        13.HYDRAULIC TEST
        1. Refer to Hydraulic Test (Click here).



        NG.
        GO TO STEP 18
        OK


        14.MANUAL SHIFTING TEST
        1. Refer to Manual Shifting Test (Click here).



        NG.
        GO TO STEP 17
        OK


        15.PROBLEM SYMPTOMS TABLE CHAPTER 1
        1. Refer to Problem Symptoms Table (Click here).



        NG.
        GO TO STEP 20
        OK


        16.PROBLEM SYMPTOMS TABLE CHAPTER 2
        1. Refer to Problem Symptoms Table (Click here).



        NG.
        GO TO STEP 18
        OK


        17.PROBLEM SYMPTOMS TABLE CHAPTER 3
        1. Refer to Problem Symptoms Table (Click here).


        NEXT


        18.PART INSPECTION


          NG.
          GO TO STEP 22
          OK


          19.DTC CHART
          1. Refer to Diagnostic Trouble Code Chart (Click here).


          NEXT


          20.CIRCUIT INSPECTION

            NEXT


            21.IDENTIFICATION OF PROBLEM

              NEXT


              22.REPAIR OR REPLACE

                NEXT


                23.CONFIRMATION TEST

                  NEXT

                  END