DTC P2759 Torque Converter Clutch Pressure Control Solenoid Control Circuit Electrical (Shift Solenoid Valve SLU) |

| DTC Code | DTC Detection Condition | Trouble Area |
| P2759 | Open or short is detected in the shift solenoid valve SLU circuit for 1 sec. or more while driving (1-trip detection logic). |
|
| Related DTCs | P2759: Shift solenoid valve SLU/Range check |
| Required sensors/Components | Shift solenoid valve SLU |
| Frequency of operation | Continuous |
| Duration | 1 sec. |
| MIL operation | Immediate |
| Sequence of operation | None |
| The monitor will run whenever the following DTCs are not stored | None |
| Solenoid current cut status | Not cut |
| Battery voltage | 8 V or higher |
| Ignition switch | ON |
| Starter | OFF |
| Solenoid status from MIC | Failure |
| Output signal duty | Less than 100% |

| 1.INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE SLU) |
![]() |
Disconnect the B32 transmission wire connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 13 (SLU+) - 5 (SLU-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| 13 (SLU+) - Body ground | Always | 10 kΩ or higher |
| 5 (SLU-) - Body ground | Always | 10 kΩ or higher |
| *a | Component without harness connected (Transmission Wire) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM) |
![]() |
Disconnect the B37 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B37-33 (SLU+) - B37-32 (SLU-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| B37-33 (SLU+) - Body ground | Always | 10 kΩ or higher |
| B37-32 (SLU-) - Body ground | Always | 10 kΩ or higher |
| *a | Rear view of wire harness connector (to ECM) |
|
| ||||
| OK | ||
| ||
| 3.INSPECT SHIFT SOLENOID VALVE SLU |
![]() |
Remove shift solenoid valve SLU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 5.0 to 5.6 Ω |
Apply 12 V battery voltage to the shift solenoid valve and check that the valve moves and makes an operating noise.
| Measurement Condition | Specified Condition |
| Valve moves and makes operating noise |
| *a | Component without harness connected (Shift Solenoid Valve SLU) |
|
| ||||
| OK | ||
| ||