DTC B2282 Vehicle Speed Signal Malfunction |
DTC B2283 Vehicle Speed Sensor Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2282 | The vehicle speed signal information from the cable and the vehicle speed signal information from the CAN communication line are inconsistent. |
|
| DTC Code | DTC Detection Condition | Trouble Area |
| B2283 | Both conditions are met:
|
|


| 1.CHECK HARNESS AND CONNECTOR (BATTERY - POWER MANAGEMENT CONTROL ECU) |
![]() |
Disconnect the F80 power management control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F80-2 (AM21) - Body ground | Always | 9.5 to 14 V |
| F80-1 (AM22) - Body ground |
| *a | Rear view of wire harness connector (to Power Management Control ECU) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - BODY GROUND) |
Disconnect the F80 power management control ECU connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F80-6 (GND) - Body ground | Always | Below 1 Ω |
| F80-5 (GND2) - Body ground |
| *a | Rear view of wire harness connector (to Power Management Control ECU) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - COMBINATION METER) |
Disconnect the F80 power management control ECU connector.
Disconnect the F14 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F80-23 (SPD) - F14-28 (+S) | Always | Below 1 Ω |
| F80-23 (SPD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.READ VALUE USING TECHSTREAM (VEHICLE SPEED SIGNAL) |
Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Power Source Control / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Vehicle Speed Signal | Vehicle speed signal / Stop or Run | Stop: Vehicle stopped Run: Vehicle driven (5 km/h (3 mph) or higher) | - |
|
| ||||
| OK | ||
| ||
| 5.CHECK POWER MANAGEMENT CONTROL ECU |
Using an oscilloscope, check the vehicle speed input signal waveform from the combination meter at the terminal of the power management control ECU.

| *a | Component with harness connected (Power Management Control ECU) | - | - |
![]() |
Check the signal waveform according to the condition(s) in the table below.
| Tester Connection | Tool Setting | Condition | Specified Condition |
| F80-23 (SPD) - Body ground | 5 V/DIV., 10 ms./DIV. | Engine switch on (IG), vehicle being driven at approx. 5 km/h (3 mph) | Correct waveform as shown in illustration |
|
| ||||
| OK | ||
| ||