DTC C1432 Steering Angle Sensor Power Source Voltage Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1432 | A steering angle sensor power supply malfunction signal is received from the steering angle sensor. |
|

| 1.CHECK DTC (CAN COMMUNICATION SYSTEM) |
Check for DTCs (Click here).
| Result | Proceed to |
| CAN DTC is not output | A |
| CAN DTC is output | B |
|
| ||||
| A | |
| 2.CHECK TERMINAL VOLTAGE (IG, BAT) |
Make sure that there is no looseness in the locking part and connecting part of the connectors.
Disconnect the F19 steering angle sensor connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| F19-5 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| F19-6 (BAT) - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector (to Steering Angle Sensor) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (GROUND CIRCUIT) |
Turn the ignition switch off.
Disconnect the F19 steering angle sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F19-2 (ESS) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||