Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR

STEERING ANGLE SENSOR > REMOVAL

for Preparation Click here



1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE STEERING WHEEL ASSEMBLY
  1. Remove the steering wheel assembly (Click here).



4. REMOVE LOWER STEERING COLUMN COVER


    C216494
  1. Remove the 2 screws.

  1. Detach the 2 claws to remove the steering column lower cover.



5. REMOVE UPPER STEERING COLUMN COVER


    C216495
  1. Detach the 4 clips.

  1. Detach the claw to remove the steering column upper cover.



6. REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR
  1. Remove the spiral cable with steering angle sensor .

    NOTICE:
    1. Do not replace the spiral cable with the battery connected and the ignition switch ON.
    2. Do not rotate the spiral cable with the battery connected and the ignition switch ON.
    3. Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
    4. Do not remove the steering angle sensor from the spiral cable.