DTC C2194/94 Engine Speed Signal Error (Test Mode DTC) |
| DTC Code | Detection Condition | Trouble Area |
| C2194/94 | The test mode procedure is performed. |
|

| 1.READ VALUE USING TECHSTREAM (ENGINE SPEED) |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
Check that the values indicated on the Techstream and on the combination meter are the same.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Engine Speed | Engine speed/ min.: 0 rpm max.: 65535 rpm | Almost same as actual engine speed | The speed indicated on the combination meter. |
|
| ||||
| OK | ||
| ||
| 2.INSPECT TIRE PRESSURE WARNING ECU (TACH SIGNAL) |
Disconnect the F7 ECU connector.
Start the engine.
![]() |
Check the waveform of the ECU connector using an oscilloscope while idling the engine.
| Tester Connection | Condition | Specified Condition |
| F7-4 (TACH) - F7-9 (GND) | Idling | Correct waveform is as shown |
| Item | Contents |
| Tool Setting | 5 V/DIV., 10 ms/DIV. |
| *a | Rear view of wire harness connector (to Tire Pressure Warning ECU) |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU - ECM) |
Disconnect the F7 ECU connector.
Disconnect the F50 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F7-4 (TACH) - F50-29 (TACH) | Always | Below 1 Ω |
| F7-4 (TACH) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||