DOOR CONTROL TRANSMITTER (w/o Smart Key System) > INSPECTION |
| 1. INSPECT DOOR CONTROL TRANSMITTER MODULE |
Inspect the operation of the transmitter.
Remove the battery (lithium battery) from the transmitter (Click here).
![]() |
Install a new or normal battery (lithium battery).
From outside the vehicle, approximately 1 m (3.28 ft) from the driver side outside door handle, test the transmitter by pointing its key plate at the vehicle and pressing a transmitter switch.
Inspect the battery capacity.
Remove the battery from an transmitter that does not operate (Click here).
Attach a lead wire (0.6 mm (0.0236 in.) or less in diameter including wire sheath) with tape or equivalent to the negative terminal.
![]() |
Carefully extend the lead wire out from the position shown in the illustration and install the previously removed transmitter battery.
![]() |
Using an oscilloscope, check the transmitter battery voltage waveform.
| Tester Connection | Tool Setting | Condition | Specified Condition |
| Battery positive (+) - Battery negative (-) | 0.5 V/DIV., 100 ms/DIV. | Ignition switch off, all doors closed and lock or unlock switch pushed | 2.2 to 3.2 V (Refer to waveform) |