Home › Drivetrain ยท VF2A TRANSFER / 4WD / AWD › TRANSFER ASSEMBLY

TRANSFER ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL TRANSFER ASSEMBLY
  1. Install the transfer to the transmission.

  1. Install the 8 bolts.

    Torque:
    24 N*m{ 245 kgf*cm , 18 ft.*lbf }



2. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY
  1. Install the automatic transmission (Click here).



3. ADD TRANSFER OIL


    C217364
  1. Remove the filler plug and gasket.

  1. Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the filler plug hole.

    NOTICE:
    1. Add oil slowly.
    2. Add oil a little at a time, waiting several minutes between each addition of oil.

    HINT:
    1. Viscosity:
      SAE 75W

      Capacity:
      1.0 liters (1.1 US qts, 0.9 lmp.qts)

  1. Wait approximately 5 minutes and check that the oil level has not changed.

  1. Install a new gasket to the filler plug and then tighten the plug.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



4. CHECK FOR TRANSFER OIL LEAK