Home › Drivetrain ยท A750F AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Install the switch to the manual valve shaft.

  1. Temporarily install the bolt.



    C155871E02
  1. Install a new lock washer and the nut.

    Torque:
    6.9 N*m{ 70 kgf*cm , 61 in.*lbf }

    Text in Illustration 
    *1
    New Lock Washer



    C212493E01
  1. Turn the control shaft lever LH clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.



    D025795E19
  1. Align the groove with the neutral basic line.
    Text in Illustration 
    *1
    Neutral Basic Line
    *2
    Groove

  1. Hold the switch in position and tighten the bolt.

    Torque:
    13 N*m{ 130 kgf*cm , 10 ft.*lbf }

  1. Using a screwdriver, bend the tabs of the lock washer.

  1. Connect the switch connector.



2. ADJUST SHIFT LEVER POSITION
  1. Remove the rear console box (Click here).

  1. Move the shift lever to N.



    C203381E01
  1. Slide the slider in the direction shown in the illustration and pull out the lock piece.
    Text in Illustration 
    *1
    Slider
    *2
    Lock Piece



    C204598E04
  1. Push the lock piece into the adjuster case and lock it.

    NOTICE:
    Make sure that the lock piece is completely locked by the slider.

  1. Install the rear console box (Click here).



3. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    D025795E19
  1. Loosen the bolt of the park/neutral position switch and move the shift lever to N.
    Text in Illustration 
    *1
    Neutral Basic Line
    *2
    Groove

  1. Align the groove with the neutral basic line.

  1. Hold the switch in position and tighten the bolt.

    Torque:
    13 N*m{ 130 kgf*cm , 10 ft.*lbf }

  1. After the adjustment, perform the on-vehicle inspection (Click here).