Home › Drivetrain ยท AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL CARRIER ASSEMBLY (w/o Differential Lock)

REAR DIFFERENTIAL CARRIER ASSEMBLY (w/o Differential Lock) > INSTALLATION

for Preparation Click here



1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY
  1. Install a new gasket and the differential carrier assembly with the 10 nuts and 10 washers.

    Torque:
    52 N*m{ 530 kgf*cm , 38 ft.*lbf }



2. INSTALL REAR AXLE SHAFT LH
  1. Install the rear axle shaft LH (Click here).



3. INSTALL REAR AXLE SHAFT RH

HINT:
Use the same procedure described for the LH side.



4. INSTALL PROPELLER SHAFT ASSEMBLY
  1. Install the propeller shaft assembly (Click here).