Home › Brake › PARKING BRAKE › PARKING BRAKE PEDAL

PARKING BRAKE PEDAL > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
  1. Remove the lower No. 1 instrument panel airbag assembly (Click here).



3. REMOVE REAR CONSOLE BOX ASSEMBLY
  1. Remove the rear console box assembly (Click here).



4. REMOVE AIRBAG SENSOR ASSEMBLY


    B240195
  1. Disconnect the connector.

  1. Remove the 3 bolts and airbag sensor.



5. REMOVE YAW RATE AND ACCELERATION SENSOR


    C212848
  1. Remove the 2 bolts and yaw rate and acceleration sensor.

  1. Disconnect the connector, and then detach the clamp from the sensor bracket.



6. REMOVE TURN SIGNAL FLASHER ASSEMBLY


    E199221
  1. Disconnect the connector.

  1. Remove the nut and flasher.



7. REMOVE TIRE PRESSURE WARNING ECU


    C216509
  1. Disconnect the connector.

  1. Remove the bolt and tire pressure warning ECU.



8. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY


    D028115
  1. Release the parking brake pedal.

  1. Disconnect the parking brake switch connector.

  1. Remove the 3 nuts and parking brake control pedal assembly.



9. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY
  1. Transmission type A750F:
    Remove the transmission floor shift assembly .

  1. Transmission type A750E:
    Remove the transmission floor shift assembly .



10. REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY


    C217117
  1. Remove the lock nut and adjusting nut.

  1. Remove the clip.

  1. Pull up the parking brake pedal claw.

  1. Remove the No. 1 parking brake cable assembly.



  1. Remove the 4 nuts and 3 bolts from the No. 1 parking brake cable assembly.


    C215294



    C215295
  1. Remove the lock nut, adjusting nut and No. 1 parking brake cable assembly from the parking brake equalizer.



11. REMOVE PARKING PEDAL PAD
  1. Remove the parking pedal pad.