Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION ECU

OCCUPANT CLASSIFICATION ECU > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing (Click here).

NOTICE:
  1. When removing the front seat assembly RH, perform zero point calibration and the sensitivity check (Click here).
  2. When replacing the occupant classification ECU, perform zero point calibration and the sensitivity check (Click here).



2. REMOVE FRONT SEAT ASSEMBLY RH

HINT:
Refer to the procedures up to Remove Front Seat Assembly (Click here).



3. REMOVE OCCUPANT CLASSIFICATION ECU


    E199503E01
  1. Disconnect the 2 connectors.

  1. Using a screwdriver, detach the claw and remove the occupant classification ECU.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape