LIGHTING SYSTEM > ACC Signal Circuit |

| 1.READ VALUE USING TECHSTREAM (IGNITION SWITCH) |
Using the Techstream, read the Data List (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| ACC SW | Ignition switch ACC signal / ON or OFF | ON: Ignition switch ACC OFF: Ignition switch off | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (BATTERY - MAIN BODY ECU) |
![]() |
Remove the main body ECU (Click here).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A-29 (ACC) - Body ground | Ignition switch ACC | 11 to 14 V |
| *a | Front view of wire harness connector (to Main Body ECU) |
|
| ||||
| OK | ||
| ||