MAIN BODY ECU > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE DOOR SCUFF PLATE ASSEMBLY LH |
![]() |
Put protective tape around the door scuff plate assembly LH.
| *1 | Protective Tape |
Using a screwdriver, detach the 4 clips, 10 claws and 2 guides to remove the door scuff plate assembly LH.
| 3. REMOVE COWL SIDE TRIM BOARD LH |
![]() |
Remove the clip.
Detach the clip and claw to remove the cowl side trim board LH.
| 4. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH |
Put protective tape around the No. 1 instrument cluster finish panel garnish.
Grip the No. 1 instrument cluster finish panel garnish and pull it diagonally upward toward the rear to detach the 5 clips and remove the No. 1 instrument cluster finish panel garnish.

| *1 | Protective Tape | - | - |
| 5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY |
![]() |
Using a screwdriver, detach the 2 claws to open the cover.
| *1 | Protective Tape |
![]() |
Remove the 2 bolts <C>.
Detach the 13 clips and 2 guides.
Disconnect each connector and hood lock control cable assembly and remove the lower instrument panel finish panel sub-assembly.
| 6. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY |
![]() |
Remove the 4 bolts and airbag assembly.
Disconnect the connector.
| 7. REMOVE DRIVER SIDE JUNCTION BLOCK ASSEMBLY |
![]() |
Disconnect the 3 connectors.
![]() |
Disconnect the 2 connectors labeled (1) as shown in the illustration.
Disconnect the connector labeled (2).
![]() |
Remove the bolt and 2 nuts and disconnect the driver side junction block assembly.
![]() |
Detach the claw and disconnect the connector as shown in the illustration.
![]() |
Detach the 2 claws and release the connector's lock as shown in the illustration.
![]() |
Detach the claw and disconnect the connector as shown in the illustration.
Remove the driver side junction block assembly.
| 8. REMOVE MULTIPLEX NETWORK BODY ECU |
![]() |
Press the claw of the junction block as shown in the illustration to release the lock.
| *1 | Multiplex Network Body ECU |
| *2 | Driver Side Junction Block |
| *3 | Protective Tape |
With the junction block lock released, insert a screwdriver with its tip wrapped with protective tape horizontally between the multiplex network body ECU and junction block.
![]() |
Using the screwdriver, carefully raise the multiplex network body ECU until the connector becomes disengaged.
![]() |
Raise the multiplex network body ECU as shown by arrow (1), and then pull it out as shown by arrow (2) in the illustration.