Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › AUTOMATIC RUNNING BOARD SYSTEM

AUTOMATIC RUNNING BOARD SYSTEM > Side Auto Step ECU Power Source Circuit

for Preparation Click here


WIRING DIAGRAM


B295283E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (SIDE AUTO STEP CONTROLLER ECU - BODY GROUND)
  1. Disconnect the A41 side auto step controller ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A41-1 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (POWER SOURCE)
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A41-4 (B) - Body ground
    Always
    11 to 14 V



B
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)