Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › AUTOMATIC RUNNING BOARD SYSTEM

AUTOMATIC RUNNING BOARD SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.


Auto Running Board System 
Symptom
Suspected Area
See page
The automatic running board does not function.
PRB fuse
Click here
Side auto step switch assembly
Click here
Proceed to "Side Auto Step ECU Power Source Circuit"
Click here
Proceed to "Side Auto Step Switch Circuit"
Click here
Proceed to "Door Courtesy Switch Circuit"
Click here
Side auto step controller ECU assembly
Click here
The automatic running board is not stowed even when the door is closed.
Proceed to "Door Courtesy Switch Circuit"
Click here
Side auto step controller ECU assembly
-
The automatic running board is not stowed even when the vehicle is moving.
Proceed to "Speed Signal Circuit"
Click here
Main body ECU (Multiplex network body ECU)
-
The automatic running board reverses operation during deploying or stowing movement.
Check that there is no foreign object blocking the automatic running board.
-
Check that there is no damage to the automatic running board link.
-
Side auto step motor assembly
-