VALVE BODY ASSEMBLY > INSTALLATION |
| 1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY |
Install the spring and check ball body.
![]() |
Insert the pin of the manual valve into the hole of the manual valve lever.
| *1 | Pin |
![]() |
Install the transmission valve body assembly with the 19 bolts.
Install the detent spring cover and detent spring with the bolt.
| 2. CONNECT TRANSMISSION WIRE |
![]() |
Connect the 7 connectors to the solenoid valves.
Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.
| *1 | Orange |
| *2 | Blue |
| 3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY |
Coat a new O-ring with ATF and install it to the oil strainer.
Install the oil strainer with the 4 bolts.
| 4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY |
Install a new gasket and the oil pan with the 20 bolts.
| 5. ADD AUTOMATIC TRANSMISSION FLUID |
Add automatic transmission fluid (Click here).
| 6. PERFORM RESET MEMORY |
Perform the RESET MEMORY procedures (A/T initialization) (Click here).