Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (for Radio and Display Type)

REAR VIEW MONITOR SYSTEM (for Radio and Display Type) > TERMINALS OF ECU

for Preparation Click here



REAR TELEVISION CAMERA ASSEMBLY

E267064E01

  1. Disconnect the Y2 rear television camera assembly connector.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    Y2-6 (CB+) - Y2-5 (CGND)
    R - BR
    Power source
    Within 60 seconds of turning the ignition switch to ACC
    5.5 to 7.05 V
    Y2-5 (CGND) - Body ground
    BR - Body ground
    Ground
    Always
    Below 1 Ω

  3. Reconnect the Y2 rear television camera assembly connector.

  4. Check for pulses between each terminal of the connector.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    Y2-2 (CV-) - Y2-3 (CV+)
    B - W
    Video signal
    Ignition switch ON
    Shift lever in R
    Camera lens not covered, displaying an image
    Pulse generation
    (See waveform 1)
    Ignition switch ON
    Shift lever in R
    Camera lens covered, blacking out screen
    Pulse generation
    (See waveform 2)

    HINT:
    1. A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the rear television camera assembly with the connector connected.
    2. If the result is not as specified, the rear television camera assembly may be malfunctioning.



  5. E171712E31
  6. Reference (Oscilloscope waveform):

    HINT:
    A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the rear television camera assembly with the connector connected.


    1. Waveform 1 (camera lens is not covered, displaying an image)
      Item
      Content
      Terminal No. (Symbol)
      Y2-2 (CV-) - Y2-3 (CV+)
      Tool Setting
      200 mV/DIV., 50 μsec./DIV.
      Condition
      Ignition switch ON, shift lever in R

      HINT:
      The video waveform changes according to the image sent by the rear television camera assembly.

    2. Waveform 2 (camera lens is covered, blacking out the screen)
      Item
      Content
      Terminal No. (Symbol)
      Y2-2 (CV-) - Y2-3 (CV+)
      Tool Setting
      200 mV/DIV., 50 μsec./DIV.
      Condition
      Ignition switch ON, shift lever in R

      HINT:
      The video waveform changes according to the image sent by the rear television camera assembly.

      Text in Illustration 
      *a
      Waveform 1 (camera lens is not covered, displaying an image)
      *b
      Waveform 2 (camera lens is covered, blacking out the screen)
      *c
      Synchronization Signal
      *d
      Video Waveform


RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)