Home › Audio / Visual / Telematics › AUDIO / VIDEO › BACK DOOR SPEAKER

BACK DOOR SPEAKER > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE BACK DOOR TRIM PANEL ASSEMBLY


    B240234
  1. Detach the 12 clips by pulling the back door trim panel assembly.



3. REMOVE REAR NO. 2 SPEAKER ASSEMBLY
  1. Disconnect the connector.



    B240331
  1. Remove the 3 screws.

  1. Detach the 2 claws and remove the speaker.

    NOTICE:
    Do not touch the cone of the speaker.