Home › Drivetrain ยท AXLE AND DIFFERENTIAL › FRONT AXLE HUB (for 4WD)

FRONT AXLE HUB (for 4WD) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH
  1. Apply MP grease to a new O-ring.

  1. Install the O-ring to the axle hub.

  1. Install the dust cover and axle hub to the steering knuckle with the 4 bolts.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }



2. INSTALL FRONT AXLE SHAFT NUT
  1. Clean the threaded parts on the drive shaft and axle shaft nut using a non-residue solvent.

  1. Install the front axle shaft nut.

    Torque:
    235 N*m{ 2396 kgf*cm , 173 ft.*lbf }

  1. Install the adjusting cap and cotter pin.



3. INSTALL FRONT AXLE HUB GREASE CAP
  1. Install the axle hub grease cap.

    NOTICE:
    Make sure the grease cap is securely installed to the axle hub.



4. INSTALL FRONT DISC
  1. Align the matchmarks and install the front disc.

    HINT:
    When replacing the disc with a new one, select the installation position where the disc has the smallest runout.



5. INSTALL DISC BRAKE CYLINDER ASSEMBLY LH
  1. Install the disc brake cylinder assembly with the 2 bolts.

    Torque:
    123 N*m{ 1254 kgf*cm , 91 ft.*lbf }

  1. Using a union nut wrench, connect the brake tube to the disc brake cylinder assembly.

    Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).



6. BLEED BRAKE LINE
  1. Bleed the brake line (Click here).



7. CHECK FLUID LEVEL IN RESERVOIR


    C208936
  1. Turn the engine switch off and fully depress the brake pedal 40 times or more to release the pressure in the accumulator.

    HINT:
    When the pressure in the accumulator is released, the pedal stroke will lengthen.

  1. Adjust the fluid level so that it is at the MAX line.

    HINT:
    When the engine switch is turned on (IG), brake fluid is sent to the accumulator and the fluid level decreases by approximately 10 mm (0.394 in.) from the MAX line.

    Brake fluid:
    SAE J1703 or FMVSS NO. 116 DOT 3



8. CHECK FOR BRAKE FLUID LEAKAGE


9. INSTALL FRONT WHEEL

Torque:
112 N*m{ 1142 kgf*cm , 83 ft.*lbf }



10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
  1. Inspect and adjust the front wheel alignment (Click here).



11. CHECK SPEED SENSOR SIGNAL
  1. Inspect the speed sensor signal .