Home › Drivetrain ยท AXLE AND DIFFERENTIAL › REAR AXLE SHAFT

REAR AXLE SHAFT > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE REAR WHEEL


3. DRAIN BRAKE FLUID


4. DISCONNECT REAR FLEXIBLE HOSE LH


    F043125
  1. Remove the union bolt, gasket and rear flexible hose from the rear disc brake cylinder.



    C214597
  1. Disconnect the brake tube from the rear flexible hose with a union nut wrench while holding the rear flexible hose with a wrench.

    NOTICE:
    1. Do not bend or damage the brake tube.
    2. Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

  1. Remove the clip.



5. REMOVE REAR SPEED SENSOR LH


    C212844
  1. Disconnect the speed sensor connector.

  1. Remove the nut and speed sensor.

    NOTICE:
    Pull out the sensor while trying as much as possible not to rotate it.



6. REMOVE PARKING BRAKE ASSEMBLY
  1. Remove the parking brake assembly (Click here).



7. REMOVE REAR AXLE SHAFT WITH PARKING BRAKE PLATE LH


    F042741
  1. Remove the 4 nuts and rear axle shaft with parking brake plate.

  1. Remove the O-ring.



8. REMOVE REAR AXLE SHAFT OIL SEAL LH


F042742E01
  1. Using SST, remove the rear axle shaft oil seal.

    SST
    09308-00010